How to record a measurement and acknowledge a warning

Before you start

Open the batch from the Production console.
Press + Add measurement (in the top bar or below Measurements).
In Measurement type choose what you measured.
In Value enter the number, for example 27.5.
Press Record the measurement.
If the value is within the limit, you see "The measurement (…) is recorded." You are done.
If the value is out of range, you see "The measurement (…) is recorded out of range; see the warning." and a WARNING card at the top.
On the card, write in Operator comment what you did (for example "lowered the temperature").
Press Acknowledge and continue. You see "The warning is acknowledged."

Screenshot: to be added

A warning card with the value, the limit, the operator comment and the acknowledge button

…it says the value is not a number. Enter only a number, without a unit or other symbols.
…the measurement is out of range. Production does not stop. The card stays until it is acknowledged, and without acknowledgement the batch cannot be completed.
…I entered a wrong value. A measurement cannot be deleted. Record a new measurement with the right value and, if a warning came out, explain the mistake in the comment.
…it says "Write a comment." The operator comment is required for the acknowledgement.